Komatsu — ADJUSTING WORK EQUIPMENT POSTURE

. OPERATION OPERATION 1.8 lbft) level indicators. 3 - 72 ADJUSTING BUCKET 1. Lower the bucket to angle, return the bu digging osition, then lock the work e quipment control lever w ith the saf ety lock lever and stop the e 2. Loosen two bolts (1 proximity switch so th at the rear tip of angle (2 ) is in line with the center of the sensin g surface of proximity . Then tighten the bolts to h old the bracket in positi 3. Loosen two nuts (5) and adjust to make a c learance o f 3 to 5 mm (0.12 to 0.20 in) between bar (2) and th e sensing surface of proximity switch (3 ). Then tightenthe nuts to hold in p osition. Tightening torque: 1 4. After adjusting, start the engine and raise th e lift arm.

Operate the bucket control leve r to the DUMP position, then operate it to the TILT BACK position and check tha t the leve r is automatically return ed to the HOLD position when the bucket rea ches the desired diggin BUCKET LEVEL INDI (A) and (B) at the top re They check the bucket a ngle during operations. (A): Parallel with cutting (B): 90 degrees to cuttin