Komatsu — ADJUSTING WORK EQUIPMENT POSTURE

. OPERATION OPERATION ADJUSTING WORK EQUIPMENT POSTURE WARNING 3 - 71 Stop the machine on flat groun d and put blocks in front and behind the wheels. Apply the parking brake. Secure the front and rear fram Always attach the warning tag to the work equipment contro l lever. D o not go under the work equ ipment when the arm is raised The boom kickout makes it possible to set the bucket so tha t it automatically stops at the des ired lifting height (lift arm hi gher th an horizontal) and the bucket po sitioner makes it possible to set the bucket so that it automaticall y stops at the desired diggi ng angle. The setting can be adjusted t o match the working conditions.

ADJUSTING BOOM KICK OUT esired height, set the lift arm control 1. Raise the bucket to the d lever at HOLD and lock th lever. Then stop the engi 2. Loosen two bolts (1), and edge is in line with the proximity switch (3). The position. 3. Loosen two nuts (4) to m to 0.197 in) between pla proximity switch (3). The Tightening torque: 17.2 ± 1.8 lbf 4. After adjusting, start the e lever. Check that the lev when the bucket reaches 1. Raise the bucket to the d m control ever at HOLD and lock th e lever in position with the s afety l ock ever. Then stop the engi ne and adjust as follows. e bottom 2.

Loosen two bolts (1), and edge is in line with the adjust plate (2) so that th center of the sensing s urface of proximity switch (3). The n tighten the bolts to hold th e plat e in position. 3. Loosen two nuts (4) to m ake a clearance of 3 to 5 m m (0.118 to 0.197 in) between pla te (2) and the sensing s urface of proximity switch (3). The n tighten the nuts to hold in position. Tightening torque: 17.2 ± 2.5 Nm (1.75 ± 0.25 kgm, 12.7 ± t) 4. After adjusting, start the e ngine and operate the lift ar m control ever. Check that the lev er is automatically returned to HOLD when the bucket reaches the desired height.