. OPERATION TRANSPORTATION TRANSPORTATION Always obey the traffic regulations when transporting the machine by road. LOADING, UNLOADING WORK WARNING When loading or unloading, always use ramps or a platform. Proceed as follows. LOADING 1. Load and unload on firm level ground only. Maintain a safe distance from the edge of a road. 2. Apply the brakes on the trailer securely and insert blocks under the tires to ensure that the trailer does not move. Then fix the ramps in line with the centers of the trailer and the machine. Be sure that the two sides are at the same height. Make the angle of the ramps a maximum of 15 є . Set the distance between the ramps to match the center of the tires.
If the ramp sags appreciably, reinforce it with blocks, etc.. 3. Determine the direction of the ramp, then slowly load the machine. 4. Load the machine correctly in the specified position on the trailer. 3 - 81 TRANSPORTATION PROCEDURE ansport the machine on a trailer. , see the weights and dimensions given in Section "SPECIFICATIONS (PAGE 5-2)". As a basic rule, always tr When selecting the trailer , see the weights and dimensions given in Section "SPECIF Note that the specification s for the weights and dimensions for transportation differ acc ording to the type of tires and type of bucket.
When loading or unloadin g the machine, run the engine at low speed, travel at low speed, an When loading or unloadin In addition, keep well awa Use ramps of ample width , length, thickness, and strength, and install them securely at an a When using an embankm ent, compact the fill soil thoroughly and make sure that the slope f Remove the mud stuck to the undercarriage to prevent the machine from slipping to the side In addition, remove any w ater, snow, ice, grease, or oil from the ramps. n the ramps. There is danger that the machine may tip over.
Never change direction o If it is necessary to chang e direction, return to the ground surface or the trailer platform, corre ct the direction, and start again. The position of the center of gravity of the machine will change suddenly at the connection o f the ramp and trailer, and there is danger of the machine losing its balance. Always drive slowly over this point.