. OPERATION TROUBLESHOOTING TROUBLESHOOTING PROCEDURE FOR BLEEDING AIR CAUTION fill the inside of the filter with 3 - 91 WHEN MACHINE RUNS OUT When s tarting after running out of f uel, fill with fuel, then bleed the air from the fuel syste This e ngine consists of higher precis ion parts than on the conventional fuel injection pump and nozzle, so if dirt gets in , it will cause problems. If there is any dirt s tuck to the fuel line, use fuel to wash it off completely. Be ca reful when opening the air blee d plug at the fuel filter head and the air bleeder of the sup ply pump. The system is still under pressure and fuel may spurt o ut. 1. clea n fuel, taking care not to let it ag ain.
Add add fuel from small hole (A) (dir fuel from hole (B) (clean si If cl ean fuel is not available, go 2. Loosen air bleed plug (2) at the 3. Loosen the knob of priming pum che ck that fuel comes out from 4. Tighten air bleed plug (2). Tightening torque: 7.8 to 9.8 Nm 5. Loosen air bleeder (4) of the su 6. Pum p priming pump (3) (approx bubbles come out with the fuel fr air b leeder (4). Tightening torque: 4.9 to 6.9 Nm 7. Continue pumping until priming pump (3) becomes stiff. (3) in and tighten it. 8. Pus h the knob of priming pump 9. Tur n the key in the starting switc h to the START position and start the engine. If the en gine does not start, r epeat the procedure from Step 2.