Komatsu — METHOD OF TOWING MACHINE

. OPERATION TROUBLESHOOTING METHOD OF TOWING MACHINE WARNING on the disabled machine cannot be 3 - 92 Injury or death could result if a there is a mistake in the selecti Always confirm that the wire strength for the weight of th Never use a wire rope which or kinks (C). There is danger operation. Always wear leather gloves Never tow a machine on a sl Never go between the towin the towing operation. If the machine moves sudde wire or drawbar, and the to machine gradually to a cons Be extremely careful if there the brakes will not work. If the steering and the bra operated, do not let anyone NOTICE acity for this machine is 207500 N (21160 kg). Do not tow any load greater than this.

The permissible towing cap acity for this machine is 207500 N (21160 kg). Do not tow an Towing is only permitted in order to move a disabled machine to a place where it is possible to carry out inspection and towed for long distances. u distributor for information about towing a disabled machine. and maintenance. It must not be Please consult your Komats u distributor for information about towing a disabled machi This machine must not be to wed except in emergencies. When towing the machin e, take the following precautions. Before releasing the brak es, put blocks under the wheels to prevent the machin e from moving. If the wheels are not blocked, the machine may suddenly move.

When towing a machine, tow it at a low speed of less than 2 km/h (1.2 MPH), a nd for a distance of a few meters to a place where repairs c an be carried out. The machine should be towed onl y in emergencies. If the machine must be moved long dist ances, use a transporter. the same class as the machine being towed. Use a towing machine of Check that the towing ma chine has ample braking power, weight, and rimpull to allow it to control both machines on slopes or on the tow r oad. pin for both the towing machine and the machine being towed.

Use the specified towing pin for both the towing machine and the machine bei To protect the operator if t he towing wire or towing bar breaks, install protective p lates on both the towing machine and the machine being to wed. ing wire as small as possible. the center lines of the two machines to within 30 degrees. Keep the angle of the tow Keep the angle between the center lines of the two machines to within 30 deg When towing down a slop e, use two towing machines. One machine should be uphill from the disabled machine and should be connected with towing wire or a drawbar to pull the disabled mac hine back and keep it stable. The other machine should tow the disabled machine downhill.