Komatsu — METHOD OF TOWING MACHINE

. OPERATION TROUBLESHOOTING differing conditions, so it is impossible to determine beforehand the the minimum rimpull, while towing on slopes or on uneven road 3 - 93 requireme nts for towin Towing on flat horizon surfaces w ill require th e maximum rimpull. WHEN ENGINE RUNS If the trans mission an be machine o ut of mud or to move it fo r a short distance to the edge of the r The opera tor should si hine being t owed an ering in the directio n that the machine is WHEN ENGINE DOES NOT RUNS ne stopped, use the following procedure. When towing a machine with the engi ne stopped, use the following procedu 1. 2. 3. 4. 1.

The trans mission oil d oes not lubri cate the system, so r emove t he front an d rear drive shafts. If necessary, b lock the tires t o prevent th e machine fr om moving. he steering cylinder. 2. The steer ing cannot b e operated, so remove t he steer Even if th e brakes are in good co ndition, the brakes c an only be used a limited number of times. There i s no change i n the operating force for the brake pedal, but the braking force is reduced each time the pedal is d. eac the ped is depresse 3. Connect t he towing eq uipment sec urely. Whe n carryin g out towing oper ations, use t wo machines o f at leas t the same cla ss as the ma chine being towed.

Connect one machine each to the front an d rear of the machine b eing towed, th en remove t he blocks fro m the tires and tow 4. Parking b The parki ng brake ca nnont be tur ned OFF. T o releas e the parking brak