Komatsu — CHECK, CLEAN, OR REPLACE AIR CLEANER ELEMENT

. MAINTENANCE SERVICE PROCEDURE 4 - 19 CLEANING OR REPLACING OUTER E LEMENT n remove cover (2). r and the cover. an 0.69 MPa (7 kg/ cm2, 99.4 1. Remove lock (1) of the cover, the 2. Remove outer element (4). 3. Clean the air cleaner body interio 4. Direct dry compressed air (less th PSI)) to the element from inside from outside along its folds and a 1) Remove one seal every time 2) Replace the outer element if repeatedly or used througho element at the same time. 3) Replace both inner and out indicator red piston appear cleaned outer element eve cleaned 6 times. 4) Remove actuator valve (3), th air. After cleaning, install it a 1. R emove lock (1) of the cover, the n remove cover (2). 2.

R emove oute r element (4). 3. C lea n the air cleaner body interio 4. D irec t dry compressed air (less th an 0.69 MPa (7 kg/ c m2 SI)) to t he e lement from inside along its folds, then it rom outside along its folds and a 1) R emove one seal every time the element is clean 2) R eplace t he outer element if it has been cleaned times epeatedl y or used througho ut a year. Replace the inner er elements when the dust s soon after installing the n though it has not been he inner lement a t the same time. 3) R eplace ndicator leaned both inner and out red piston appear outer element eve times. leaned 6 4) R emove actuator valve (3), th en clean it with compressed ir.

A fter cleaning, install it a gain. the g the been NOTI CE If sm all holes o r thinner parts are found o n the element when it is checked with an electric bul b after cleaning and dr ying, replace the element. g. When cleaning the element, do not hit it o r beat it against somethin Do no t us e an element whose folds or ga sket or seal are damaged. 5. A fter cleanin g the element, instal l it, then install cove r (2 ). 6. A fter cleanin g or replacing the el ement, return the re d display of the dust indicator to its original position.