. MAINTENANCE SERVICE PROCEDURE TURN, REPLACE BOLT-ON CUTTING EDGE WARNING Tightening torque: 883 to 1200 Nm (90 to 122 kgm, 651 to 882 lbft) 4 - 32 It is extre mely dangerous if the work equipment moves when carr ying out the turning or r eplacement operation Set the w ork equipment in a stable po sition, stop the engine, then set the safety lock leve r for the work equipment con trol lever securely Turn or replace the cutting edge before the wear reaches the edg e of the bucke 1. Rais e the bucket to a suitable height, then put blocks un der the bucket to prev ent the bucket from comin g down. Rais e the bucket so that the bottom surface of the buc ket is h orizontal. 2.
Rem ove bolts (1) and nuts (2 ), then remove cutting ed 3. Clea n the mounting surface o 4. Turn cutting edge (3) and ins th sides of the cutting ed ge are worn, replace with 5. Tigh ten bolts (1) and nuts (2) uniformly so that there is no gap between the bucket and cutting edge ( 6. Afte r operating the machine f or a few hours, tighten th e mounting nuts again LUBRICATE WORK EQUIPMENT CONTROL VALVE LINKAGE (2 PLAC If the w ork equipment control le y, apply grease. g a grease pump, pum smoothl 1. Usin gs shown by arrows. 2. Afte r greasing, wipe off any o ld grease that was pushe