Komatsu — REPLACE BUCKET TOOTH WITH SEGMENT EDGE

. MAINTENANCE SERVICE PROCEDURE REPLACE BUCKET TOOTH WITH SEGMENT EDGE WARNING 4 - 31 It is dangerous if the work equipment moves by mistake when the tooth is being replaced Set the work equ ipment in a stable po sition, stop the en gine, then set the safety lock for the work equipment contro l lever securely to the L OCK position. There is danger of pieces flying during the replacement o peration, so always wear protecti ve clothing such a s safety g lasses and Replace the buck et teeth and the seg ment edges bef ore they wea r down to the en d face of the bucke 1. Raise the buc ket to a suitable heig ht, then put bloc ks under bucket to kee p the bottom of the bucket horizonta 2.

Remove the bolt and nuts (1) a tooth (3) and segment edge (4). 3. Clean the inst edge (4). 4. Install a new doing this, ins ert shims to remove any clearance between tooth and top surface of the buck 5. Tighten the nut temporarily so between the t ooth and tip of the bucket, then hit t he tip of tooth with a h Mounting bolt tigh tening torque 1200Nm (90 to 122kgm, 651 to 882lbft) Mounting bolt for bucket tooth: 883 to 1200Nm (90 to 122kgm , 651 Mounting bolt for segment edge: 160 0 to 2160Nm (16 3 to 220kgm , 1179 to 1591lb The segment edg e can be turned ov er and used agai n. 6. After operatin g the machine for a few hours, tight