Komatsu — REPLACE BUCKET TEETH

. MAINTENANCE SERVICE PROCEDURE ONE-PIECE TOOTH 4 - 30 When the buck et teeth are worn, replac e them as follow 1. Raise the b ucket to a s uitable height, then p ut blocks under the bucke t to k eep the bot tom of the bucket ho rizontal. 2. Remove th and tooth (3). 3. Clean the i nstallation s urface of bucket toot h (3). 4. Install new teeth to the When doin g this, insert shims so that there i s no clearance between the tee th and the top su rface of the b ucket. Continue to add shims until it becomes imp ossible t o add a 0.5 mm (0.02 5. To prevent any gap fr om formin g b etween the teeth and tip of temporarily , then hit th e tip of th e teeth with a hammer. Tightening torque:

883 to 1200 to 122 kgm, 6 51 to 8 6. After operating the ma chine for a fe w hours , tighten the mounting nuts ag