Komatsu — CHECK ALTERNATOR BELT TENSION, ADJUST

. MAINTENANCE SERVICE PROCEDURE parking brake switch to the ON position, and check if the CHECK ALTERNATOR BELT TENSION, ADJUST CHECKING The standard deflection between the drive pulley and alternator REMARK 4 - 43 CHECK PARK 1. Set the mac hine on a dry downhi e hold the mahine in positon. 2. If any proble m is found, please co ntact your Komatsu di pulley when pre ssed with a thumb (ap prox. 98.1 N (10 kg)) s be approx. 13 to 16 mm (0.51 to 0.63 ADJUSTING er mounting bolts (6) (2 places), and remov 1. Remove cov cover. 2. Loosen bolts the tension 3. After adjusti alternator (3 4. Reinstall the the cover to 1. Remove cov er mounting bolts (6) (2 places), 2.

Loosen bolts and nuts (1), (2) and (5), then tur n nut (4) to of the belt. 3. After adjusti ng, tighten bolts and n uts (1), (2) and (5) to s ). 4. Reinstall the cover removed in st ep 1. Confir m that no p uches any moving pa rt of the alte rnator. Check each p ulley for breakage an d wear of th e V-groove . In particular, check that the V -belt does not tou ch the bottom of the If any abnorm ality is found, ask yo ur Komatsu distributor for replacement of the pulley. If the V-belt i s so lengthened that i t cannot be adjusted a ny more or if it has any cuts or cracks, replace it When adjusti ng the V-belt, do not press the al ternator dir ectly with a bar, but put a woo d piece, etc.

in-between them. If the V-belt h as been replaced wit h a new part , there will b e initial elongation, so inspect and adjust it again after one-hour of o