. MAINTENANCE SERVICE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST CHECKING CHECK WHEN CHANGING THE V-BELT (48 ± 5 kgm , 347 ± 36 lbft) any stud bolt is broken, replace all the stud bolts for that wheel. 4 - 44 The standard d eflection between the air conditioner compres sor pulley and drive pulley wh en pressed with a thumb (approx. 58.8 N (6 kg)) should be ap prox. 8.5 to 11 mm (0.3 5 to 0.4 The standard d eflection between the air conditioner compres sor pulley and drive pulley wh en pressed with a thumb (approx. 98 N ( 10 kg)) should be ap prox. 6 to 8.5 mm (0.24 to 0.34 ADJUSTING t (1). knut (2).
tment bolt (3) to adjust the belt tension so that the s the specified amount. ting, tighten locknut (2). lt (1). 1. 2. 3. 4. 5. 6. 7. 1. Loosen bol 2. Loosen loc Turn adjus deflection i After adjus s the specified amou ting, tighten locknut ( 5. Tighten bo 6. Check eac h pulley for damage, w ear of the V-groove, and wear of the V-bel t. In particular, be sur e to check that the V-belt is not touching th e bottom the V-groov e. 7. Replace th e V-belt if it has stretc hed, leaving no allowan ce for adjustment , or if the belt is cut o r cracked. with a new part, there will be If the V-bel t has been replaced initial elong ation, so inspect and adjust it again after one -hour of operatio n.
CHECK FOR LOOSE WHEEL HUB NUTS, TIGHTEN I f wheel hub nu ts (1) are loose, tire wear will be increased a nd accidents may be caused. 1. Check for l oose nuts, and tighte When che cking for loose nuts, direction of tightening to check. Tightening torque: 471 ± 49 Nm 2. If