Komatsu — REPLACE FUEL FILTER CARTRIDGE

. MAINTENANCE SERVICE PROCEDURE 4 - 55 7. When install ing, tighten until the p acking surface co ntacts th e seal surface of the filter holder, the n tighten it up 1/2 to 3/4 of If the filter c artridge is tightened t oo far, the packing will be d amaged and t his will lead to leakage of fuel. If the filter cartridg e is too loose, fuel w ill also leak from th e packin g, so always t ighten to the correct a 8. After replaci ng filter cartridge (1), loosen air bleed p lug (2). 9. Loosen the knob of priming pump (3), then pump the knob an check that f uel comes out from ai r bleed plug (2). (0.8 to 1 kgm , 5.8 to 7.2 lb ply pump. 10. Tighten air b leed plug (2). Tightening t orque:

7.8 to 9.8 Nm 11. Loosen air b leeder (4) of the sup 12. Pump primin g pump (3) (approx. 9 0 to 100 times) un til no mo bubbles com e out with the fuel fro m air bleeder (4), th en tighte air bleeder ( Tightening t orque: 4.9 to 6.9 Nm ( 13. Continue pu mping until priming p ump (3) becomes 14. Push the kn ob of priming pump ( 3) in and tighten it. 15. After replaci ng the filter cartridge, start the engine a nd check that there is n o leakage of fuel from the filter seal surface. If a ny leakage of fuel is f ound, check that t he filter c artridge is tigh tened properly.

If the f uel still leaks, repeat Steps 1 and 2 to remove th e filter cartridge, th en check the packing s urface for damage or e mbedded dirt. If any proble mis found, replace th e cartridge with a n ew part, then repeat Ste ps 3 - 15 to install the n ew cartridge.