Komatsu — CLEAN RADIATOR SUB-TANK BREATHER

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4 - 59 (7) Damper (1 place) (8) Transmission mou nt trunnio n (1 place (9) Fan pull ey (1 plac (10 ) Tensio n pulley (1 CHECK TIGHTENING PARTS OF TURBOCHARGER Contact you r Komats u distribut or to have the tightening portions REPLACE CORROSION RESISTOR CARTRIDGE 1. 2. 3. 4. 5. 6. 7. 1. Open th e engine side cover located o n the righ t of t he engine 2. Set val ve (1) at esistor the CLOSE Using a D position filter wren Apply e install it ngine oil t to the filte o the seali r holder. bring the 5. When i nstalling, sea surface of the filte r holder, t hen tighte n approx. 2/3 t urns. 6. Set valv e (1) to th e OPEN p osition. 7.

After re placing th e cartridg e, start th heck there is no leakag e of wate r from the cartridge seal surface. CLEAN RADIATOR SUB-TANK BREATHER , then remove it. Remove all the breathe mud and r, immers dirt from around th e it in cleaning fluid e breather and clean Be is r careful n emoved. ot to let dirt enter through the mount while the breathe