Komatsu — CHECKING FOR LOOSENESS OF HIGH-PRESSURE CLAMP, HARDENING OF RUBBER

. MAINTENANCE SERVICE PROCEDURE EVERY 4000 HOURS SERVICE REPLACE INJECTOR CHECKING FOR LOOSENESS OF HIGH-PRESSURE CLAMP, HARDENING OF RUBBER are loose clamps or hardened or missing rubber, the connections of the 4 - 68 Maintenance for e very 50, 100, 250, 500, 1000 and 2000 hours service should be carried out at the same tim CHECK WATER PUMP Check th at there is no play in the pulley or any g rease leakage, water leakage, or clogging of the drain hole. I f any problem is found, contact your Komatsu distribu tor for disassembly and repair or r eplacemen t.

CHECK VIBRATION DAMPER Check th at there is no drum-shaped deformatio n of the surface of the damper, an d check tha t there are no tr aces of l eakag e of the d amper oil around the damper . Komatsu distributor for replacement of the parts. If a ny ab normality is found, please contact your Komatsu distributor for replacement of the pa CHECK FAN PULLEY AND TENSION PUL Check fo r pla y of th e pulley and leakage of greas e. If any problem is found, please c ontact your Komatsu distributor.

CHECK AIR CONDITIONER COMPRESSO As speci al too l is r equired for checking and adju sting the parts, request Komatsu distributor f or service As k your Komatsu distributor to carry out this w Check vi suall y an d touch with your fingers to c heck that there are no loose bolts or hardeni ng of rubber pa rts at clamps ( 1) to (15). If there is any looseness or h ardened rubber, contact your Komats u distrib utor for replacement. NOTICE ine continues to be operated when there a If t he eng ontinu high-pressure p iping may be damaged by the friction Always ch eck t hat th e high-pressure piping clamps a