. ATTACHMENTS, OPTIONS HANDLING AUTO-GREASING SYSTEM NOTICE sorrounding area dirty. SETTING CODE TABLE 6 - 7 SETTING GREASING TI ME frequency limit differs according to the operating condition and greasing plan for the ng items to carry out suitable centralized greasing. reasing interval for automatic operation ngth of time pump is operated for each greasing operation The set time and greasing condition machine, so set the followi ng items to carry out suitable centr alized greasing. Greasing interval (Hr): G reasing interval for automatic oper Greasing time (min): Le ngth of time pump is operated for e ach greasing op Greasing frequency limi t (times): No.
of times for operating pump before th e 1000 cc grease cartridge becomes empty g from the factory are as follows. 0 times et to sound after 130 hours on the hourmeter (when normal operation). The settings when shippin Greasing interval: 3 hours Greasing time: 7 minutes Greasing frequency limit: 5 The grease level alarm is s et to sound after 130 hours on the hourmeter (whe n normal operation). for the Be careful since the life of grea se cartridge will be shortened if the grea sing interva l becomes shorte r. Also, i f the greasing interval becomes shorter, the amount of grease dripping from the tip of the working machine increases.
It may m ake the machine and SETTING GREASING TIME IN COLD AREAS iscosity of the grease rises, so it is necessary to increase the greasing time. In cold temperatures, the v iscosity of the grease rises, so it is necessar y to in crease th e greasing time. For example, if the machin e is used at temperatures below -2 0°C (-4°F), set th e greasin g time t o 20 minutes (code No. 7). In addition, use lith ium-based grease No. 0. When changing the set val ue, please consult your Komatsu d METHOD OF SETTING When setting the various ite ms, the value is not input directly. S elect the c ode n umber fro m the s et code table below, and set as follows.
NOTICE When using the machine at am bient temperatures of below -20°C (-4 °F), set to gr easin g time (b) a t code N o. 7. PROCEDURE FOR SETTING ine on the flat and hard ground, and stop the engine. 1. Stop the working mach ine on the flat and hard ground, an d stop the engi 2. Set the safety lock leve r at LOCK position and set the sta rting switc h at O N positio 3. Turn the starting switch ON and start the engine.