Komatsu — METHOD OF OPERATING AUTO-GREASING SYSTEM

. ATTACHMENTS, OPTIONS HANDLING AUTO-GREASING SYSTEM ATTACHMENTS, OPTIONS HANDLING AUTO-GREASING SYSTEM set. REMARK c. After mode. setting, of the counting. 6 - 8 4. Press the LEVEL and I TEM keys at the same time to se setting mode. 5. Press the ITEM key on e or more times to select the ite Eac h time the ITEM key is pressed, the setting item is cha → b 6. When the item to be se t flashes, press the LEVEL key . →→ 0 →→ a →→ 0). The set item and nume ral are displayed alternately (a →→ 0 →→ a →→ 0) 7. Refer to the setting cod e table and press the ITEM key one or more times to selec t the code number to be set.

REMARK Eac h time the ITEM key is pressed, the code number (num eric portion) goes up by 1. 8. When the code number that is to be set flashes, press t key to carry out the set 9. completing the setting, press the ESC key to leave the REMARK Eve n if it is desired to chan ge only one item, always carry setting according to Steps 4 to 8. After completing the to leave the setting mode. always press the ESC key If th e power is then turned ON, the count for the greasing i will start immediately after the ESC key is pressed. Part display segment flashes t o indicate that the system is co Afte r setting, the set value i s retained in memory even if the is turned OFF.