Komatsu — WHEN REQUIRED

. ATTACHMENTS, OPTIONS HANDLING BRAKE COOLING SYSTEM HANDLING BRAKE COOLING SYSTEM WHEN REQUIRED CHECK AXLE OIL LEVEL, ADD OIL WARNING near the bottom of the plug hole, add axle oil (15.5 ± 2.5 kgm , 112 ± 18 lbft)) 6 - 48 An a ir-cooled oil co oler is installed to improve t he coolin g efficiency for the brake cooling For machines equip ped with the bra ke cooling system, carry out the following inspection The parts and oil are a t high temperature i mmediately after the engine is stopped, and may cause burn s.

Wait for the temperature to go down before sta Carr y out the follow ing inspection if a ny signs o f leakag e of oil from the axle case or brake cooling circuit are seen Inspect the machin e on a horizontal surface. (If th e road surface is at an angle, th e oil level cannot b 1. Start the engin e and run at low i dling for at least 5 circulate the oil in the brake cooli ng circuit. 2. Remove oil lev el plug (1), and ch eck that th e oil lev bottom edge of the plug hole whe n the engi ne is run idling. 3. If the oil is not through the plu 4. If the oil level is correct, install pl ug (1). Tightening torq ue: 152 ± 24.5 N