Komatsu — OPERATIONS AND CHECKS AFTER STARTING ENGINE

. OPERATION OPERATION OPERATIONS AND CHECKS AFTER STARTING ENGINE WARNING WARMING UP OPERATIONS NOTICE suddenly operate the levers when the Always perform the warming-up (3) flashes or the buzzer sounds 3 - 97 If there has been any Emergency stop, abnormal actuation or trouble, turn the starting switch key If the work equipment is operated without sufficiently warming the machine up, response of the wor k equipment to movement of the control lever will be slow, and the work equipment may not respond as the operator desir es, so always perform the warming-up operation. Particular BREAKING IN THE NEW MA CHINE horoughly adjusted and tested before shipment from the factory.

However, operating the king the machine in can adversely affect the performance and shorten the machine life. the initial 100 hours (as indicated on the service meter). NOTICE Your Komatsu machine has been t machine under full load before brea king the machine in can adversely affect the performance and sho Be sure to break in the machine for the initial 100 hours (as indicated on the service meter). Make sure that you fully understa nd the content of this manual, and pay careful attention to th e following points when breaking in the machine. Run the engine at idle for 15 seconds after starting it. During this time, do not operate t he control levers or fuel control dial.

after starting it up. ads or at high speeds. Idle the engine for 5 minutes Avoid operation with heavy lo Immediately after starting the engine, avoid sudden starts, sudden acceleration, unneces sary sudden stops, and sudden changes in direction. Do not perform operations or s hydraulic oil is at a low tempera operation until the hydraulic oil te range. This will help extend the m Do not suddenly accelerate the e operating temperature. Do not run the engine at low or hi will cause oil leaks from the turb If it is necessary to run the engi time or run the engine at a mid-ra If engine oil pressure caution la intermittently, stop the engine an