. OPERATION OPERATION ADJUSTING BRACE WARNING REMARK 3 - 121 If ma intenance is carried out with the e ngine running, always have one worke r sitting in the operato r's seat while another w orker carri es out the maintenance. Both wor kers must mutually confirm the safety An a djustment of the brace can ea sily be made by, after staring up the engine, tilting the blade to th e right and left through a fine con trol of the blade control lever an d turning brace handle (1) while liftin g and lowering the blade. .7 in) (A): 300mm - 400mm (11.8 in - 15 W hen extending the brace It is easy to carry out the adjustme nt if the blade is set on top of a bloc k and the brace handle is turn ed.
Wh gradually becomes heavier. When this happens, return the blade from the tilt position to the horizon tal position and turn the handle aga in according to the procedure SHIM ADJUSTMENT Adju st the thickness of shim so th at the ball joint play (6 points) in the axial direction (shown by the 4 in). arrow) does not exceed 1 mm (0.0 Remove shim (1) and tighten b olts (2) to eliminate the ball joint play. move bolts (2). Measure clearance "A" and re Adjust the thickness of shim (1 ) to (A + 0.5) - (A + 1) mm, then tighten bolt (2). Confirm that ball joint can mov e smoothly after tightening bolts.