Komatsu — ADJUSTING POSTURE OF WORK EQUIPMENT

. OPERATION OPERATION ADJUSTING RIPPER REPLACING POINT AND PROTECTOR 3 - 122 ADJUSTING DIGG Mounting pin holes are provided in the shank an d these are u sed according to the desired di gging depth . For no rma use, use the bottom hole, and when particularly deep diggin g is needed, use the 1. P lace a pointe d object on the ti p of pin ( ammer to rem ove from the opposite side. 2. Remove pin (2) and change the p osition of the shank ho 3. I nsert pin (1) pa rtially by hand the n knock it in with a ha mmer.

The pin is m ade of one piece, hand in with a hammer To p rotect the shan are worn, replace th Plac e a pin remove r on the pin marke d by the a rrow, t hen h it with a hammer to remov e from the opposi and point REMARK The pin is a unitize d type, so insert th e pi n parti ally by hand , then knoc k it in fully with a hammer.