Komatsu — LOADING, UNLOADING WORK

. OPERATION TRANSPORTATION OPERATION TRANSPORTATION 4) Secure the attachment at two places with a chain or wire rope. 3 - 133 UNLOADING WORK 1. Load and unload on fir m level ground only. Maintai n a saf e distance from the edge of 2. Apply the trailer brakes securely and put blocks (1) under the tires to hold the trailer in position.Set gap (3) betw een ramps (2) to match the distanc e between the left and right t racks, and keep angle (4) to a ma If ramps (2) bend appre ciably under the weight of the machine, put wooden block (5) u nder the ramps to support th 3. Remove the chains an d wire ropes fastening the m achine 4. Start the engine. lly. Warm the engine up fu 5.

Set main work equipme nt lock lever to FREE positio n (F), and raise the work equipme (When transporting wit nt. h work equipment installed) 6. Set parking brake lever to the FREE position (F). 7. Set the transmission in idle. the 1st gear and run the engine at low 8. Set the travel direction toward the ramps and drive slowly. 9. The center of gravity of the machine shifts sudde nly at the border between the ra unbalanced and beco border slowly. Drive down the ramps mps and trailer, and the m achin e is mes dangerous. Accordingly, pass the slowly and carefully until the machine ctly. the 10. leaves the ramps perfe