Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK ALTERNATOR DRIVE BELT TENSION, ADJUST and 4 - 49 CHECKIN G a belt at a mid point between drive pulley (1) Depress alternator pulley (2) wi th a thumb t o app ly 98 N (10 kg) - pres and when deflection a mount (A) r emain s between 13 mm a mm (0.51 i n and 0.63 i n), the d eflection is withi n the standard v ADJUSTIN 1. Remo ve cap (1), l oosen b olt (4 ), nut (2) an d (5) , and adju belt te nsion by tur ning nu t (6). 2. After t he tension a djustment, ti ghten nut ( 2) an d (5), insta (1) an d secure alt ernator REMARK Check each pulley for breakage and wear of the V-groove .

In particular, check that the V- belt does not touch the bottom of the V-gro ove. s found, ask your Komatsu distributor for replacement of the pulley. ngthened that it cannot be adjusted any more or if it has any cuts or cracks, replace it. If any a bnormality i s found , ask your Komatsu distributor If the V -belt i s so le ngthened th at it c annot be a djusted a ny more or if it has any cuts or When adjusting the V-belt , do n ot press th e alternator dir ectly with a bar, but put a wood piece, etc. in-between them. If the V -belt h as be en replaced with a new part, there will b e initial elongation, so inspect and adjust it again after one-ho ur of o perati on.