Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE NOTICE 4 - 57 When adding fuel, do not remove cap (B). Always a small holes (A) on the dirty side. After adding fuel, r emove cap (B) and install the fuel Always fill with cle an fuel. Be careful not to let any di the fuel. In particul ar, center portion is the clean side, cap (B) when addin g fuel. Be careful not to let dirt or d portion on the clea 11. When installing , tighten until the packing surfa ce contacts the seal surface of the filter holde r, then tighten it 3/4 of a turn. If the filter cartr idge is tightened too far, the pa cking will be damaged and this will lead to le akage of fuel.

If the filter cartridge i s too loose, fuel will also leak fr om the packing, so always tighten the corre When tighte ning with a filter wrench, be ext remely careful not to dent or damage the filte 12. Open valve (1) at the bottom of the fuel tank. 13. After replacing low idling for 10 Check that ther the filter cartridge, start the eng minutes. e is no oil leakage from the filte mounting surfa found, check th ce of the transparent cap. If a e tightening condition of the fi there is still oil l eakage, repeat Steps 1 - 5 to r cartridge, then check the packing surface embedded fore ign material. If any problem is the cartridge wi th a new part and repeat Steps it.