. MAINTENANCE SERVICE PROCEDURE REPLACE POWER TRAIN OIL FILTER ELEMENT WARNING 2. Remove bolts (1) and cover (2) is lifted up, then element (3). CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING mud get in when adding oil. 4 - 58 Immediately after the engi ne is stopped, the oil and pa rts are at hig h temperature, and may cause bur ns. To prevent this, wai for the temperature to go down before starting the op eration . Before opening the filter c ases, depress the brake pe dal several ti mes to release the pressure, then lock the brake pedal. I there is still pressure insid e the filter, oil may spurt ou t. 1. Open the engine side cover on the left of the m achin take out 3.
Clean inside of the ca se and the removed part s, the n inst all a new element. Replace the O-ring wi There is danger that oil may s purt out under internal pressure, s o stan d to t he side, and gradually turn th e plug to release interna pressure before removing th 1. Place the machine on a horizontal place. (G) and check whether the final drive lower edge of the plug hole. dd oil through oil level plug (G). 2. Remove oil level plug (G) and check whether case is filled with oil to lower edge of the plug 3. If the oil level is low, a dd oil through oil level pl ug (G) Before removing the o il level plug (G), remove all the mud and dirt from around the p