Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN FINAL DRIVE CASE WARNING ADD OIL (PAGE 4-58)". 4 - 62 The oil is at high temper ature immediately after the machine ha s been operated. Wait for the oil to co ol down before starting the operation. There is danger that oil spouts out due to the intern al pressure . When removing the plug, work from the side, turn the plug slowly to release the inte rnal pressure, and remove i t carefully. Refill capacity: rs (6.87US gal) rs (9.51US gal) D85EX : (each) 26 lite D85PX : (each) 36 lite 1. Stop the machine so that drain plug (H) is direc tly at the b ottom. 2. After removing oil fill er/level plug (G), remove drain plugs (H) ain.

(H) and (1), drain the oil , then tighten the plug ag 3. Add the replacement amount of oil through the hole of pl ug (G). 4. After adding oil, chec k that the oil is up to to th e specifie d level. For details, see "CH ECK OIL LEVEL IN FINA L DRIVE CASE, CHECK, CLEAN FUE L STRAINER lve (1), then remove strainer cap (2). ne unit with the strainer cap. k to the strainer, then wash in clean diesel 1. 2. 3. 4. 1. Close fuel supply va lve (1), then remove strai ner cap ( The strainer forms o Remove any dirt stuc ne unit with the strainer c k to the strainer, then wa fuel or flushing oil. If After checking and c tighten cap (2). the strainer is damaged, replace it.

leaning, set the strainer in the case, then fuel supply valve (1). 4. After installing, open