. OPERATION OPERATION ADJUSTMENT ADJUSTING OPERATOR'S SEAT WARNING NOTICE (A) Fore-and-aft adjustment Pull lever (1) up, set the seat to the desired position, then release the lever. Fore-and-aft adjustment: 190 mm (10 mm x 19 stages) (B) Adjusting seat angle Move lever (2) up, move the seat cushion at the front up or down to set to the desired position, then release the lever. Amount of adjustment Forward tilt: 3 degrees Rear tilt: 11 degrees 3 - 103 Park the machine in a safe pl ace and stop the engine when carrying out adjustment of the operato Adjust the seat position at th e beginning of each shift or when operators change.
Adjust the seat so that the br ake pedal can be depressed all the way down with the operator's bac Adjustments (C), (D), and (K) use the air compressor built into the seat, so turn the engine s tarting switch to the ON position. There is danger of damage to th e air compressor, so do not keep lever (3) operated continuously for (C) Adjusting seat height ses an air system, and it can be adjusted steplessly. The seat height adjustment u When adjusting the height, p ull lever (3) up fully or push it down fully (when pulling it up, p ull it until a click is felt). When the seat is set at the d esired height, release the lever.
If the lever is kept pulled up , the position where the seat does not rise any further is the maximum height. When the seat reaches the maximum height, the suspension automatically goes down slig htly to secure the amount of movement of the lever. If the operator raises his bod y from the seat or changes the amount of weight applied to the seat during adjustment, the air in the suspension ma y be discharged. m (3.2 in) Amount of adjustment: 80 m (D) Setting seat for weight To protect the operator, it is n ecessary to adjust the suspension to match the operator's we ight. When carrying out this adjustment, stop the ma chine, set the seat to the correct posture, then operate the le ver.
Pull up lever (3) lightly a shor t distance. The weight setting is adjusted automatically. (Th e air pressure inside the suspension is increased or d ecreased to match the operator's weight.)