Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION ADJUST ARMREST (LEFT) Open the armrest, and turn knob (2) counterclockwise to adjust the height. Only the armrest will move up. After adjusting it to the desired height, close the armrest. 1) Sit in the operator's up-down adjustment the right. knob (2) to adjust the thickness of the the support at the front. 3 - 108 The armrest on the left side o f the operator's compartment ca n be adjusted to 1. When adjusting height of both armrest and case ly adjust the standard height up 50 (2 in).

It is possible to effortless mm (2 in) or down 50 mm The steering, directional, Turn up/down left adjust Turn the knob to adjust a Turn CLOCKWISE to mo Turn COUNTERCLOCKW and gearshift lever moves as a u nit. ment knob (1) to adjust the height. s follows. ve UP ISE to move DOWN 2. When adjusting height of armrest only It is possible to effortlessl from the armrest and cas The steering, directional, y adjust up to 36 mm (1.4 in) upward e contact surface. and gearshift lever does not move. and gearshift lever does not mov 3.

By carefully adjusting to match the operator's physique, i t is possible to operate the tr and smooth steering) an adjust the armrest as follo avel lever correctly (with fine control d comfortably (with little fatigue), so ws: seat, grip the travel lever, and t knob (1) to adjust the height of urn the a position where the elbow matches armrest as shown in the diagram on el lever to the left and right, and t urn height of the armrest to match the rator's arm so that it is possible to he left and right using the elbow and t.