. OPERATION OPERATION 3. Finally, operate blade control lever (4) and ripper control lever (a) (b) (c) (d) Raise Hold Lower Float (e) (f) (g) (h) Left tilt Right tilt Digging angle increased Digging angle reduced 4. After warm-up is completed, check gauges and caution lamps for proper operation. If any problem is found, repair it. Continue to run the engine under a light load until engine coolant temperature gauge indicator (2) is within the green range (B). (A): White range (B): Green range (C): Red range REMARK If the power train oil temperature is not raised sufficiently, it will take longer to accelerate to the maximum speed. 5. Check for abnormal exhaust gas color, noise, or vibration.
If any problem is found, contact your Komatsu distributor. 3 - 121 IN COLD AREAS (AUTOMATI This machin e is equipp ed with an automati When the engine is started, if the engi operation is carried o ut automatically. ing-up operation i T he auto matic warm pecified temperatu re (30 °C (86 °F)) or if the w arming-up operation is continued for 10 minute s. If the engine coolan temperatu re or hydra ulic oil temperature are low after the automatic warming-up operati on, warm the en gine up further as follows. 1. Turn fuel control dia l (1) to the center position between LOW I DLE (M IN) and HI GH IDLE (MAX) and run the engine at th no load. at medium speed for a bout 10 minutes wi 2.
Operate blade cont rol lever (4) to the RAISE position, then k r eep the blade rais ed to the maximum height and continue to elieve th e circuit fo r 10 minutes. t I r o operat f the oil e the blade temperatu and ripper cylinders several times. re in the work equipment is not properly a time lag in the response of the work ring. rs several times. ipment is not properly aised, t here will be work equipme nt and stee