Komatsu — RIPPER OPERATION

. OPERATION OPERATION RIPPER OPERATION EFFECTIVE METHOD OF USE rear. 3 - 148 The op timum diggin g angle for the shank i dicular to the ground (ripping angle: In com paratively sof t rock (seismic velocity: 1500 m/s or below), o possible to carry out ripping with th e shank tilted to the On co mparatively h ard rock, if ripping is carried out with the shank of tip ( tilted to the re ar, there will be excess ive wear of the point 1), and the se lf-sharpening ability wil l be lost. During ripping operations, if the shoes slip because of boulders or resi When speed stance from t he bedrock, use the tilt cylinder. picking up a s tone, advance the mac hine at a fixed gear (F1 or F2).

REMARK raising boulders or digging up rockbed, do not put the transmission in neutral. If the transmission is in When neutra transm l, the reactio n of the tilt cylinder w RWARD. ill push the machine back. Always operate the machine with the ission in FO Choos ing a suitable ripper point to match th e type of rock is one of the most important el ements in using the ripper effecti Rippe details vely. r points are a vailable for different typ es of rock, so select the most suitable ripp er point from the lis t. For , see "PROCEDURE FOR SELECT ING RIPPER POINT (PAGE 6-4)".

DIGGING UP BOULDERS OR ROCKBED During rip per operation s, if stubborn boulders o r rockbed cause the travel sp eed to becom the bould