. OPERATION OPERATION ADJUSTING POSTURE OF WORK EQUIPMENT WARNING BLADE ADJUSTMENT TILTING THE TILTDOZER NOTICE 3 - 156 When adju sting, it is dangero us if the work e quipment is moved b y mistake. Set the work equipment in a safe conditi on, then stop the engine and lock the work equipment sec urely with the work equipment lock lever. The maxim um amount of tilt i s 900 mm (2.9 f (When the semi-U blade is us Be sure no t to exceed 900 m m (2.9 ft) for the Tilt exceed ing the maximum l imit imposes u nnecessar y forces o nto sections. This may cause dam age to the mach The follo wing tilt amount can be obtained by operating the blade ver. :
600 mm (23.6 in) or more 600 mm (23.6 in) or more greater tilt is necessary, do as follows. blade control le Right side : 600 mm (23.6 Left side: 600 mm (23.6 in If an even greater tilt is ne cessary, do a s follows. Use rod ( 2) installed to the left brace to turn brac e (1) and change the lengt h ( l ) of the bra ce. This makes it possible to obtain a 2.9 ft). between joints is 1845 mm (6.0 ft). obtain a maximum tilt of 900 mm ( Standa rd distance ( l ) between joint s is 1845 mm (6.0 ft).