. OPERATION TRANSPORTATION LOADING, UNLOADING WORK WARNING idle. and trailer, and the 3 - 161 TRANSPORTATION When transporting the machine , observe all related laws and regulations, and be careful TRANSPORTATION PRO When transporting the machin dimensions shown in "SPECIFI CATIONS (PAGE 5-2)". Note that machine specifications (weight and dimensions) vary depending on the kind of tr ack shoes and work equipment. Make sure the ramp has sufficien t width, length and thickness to enabl e the machine to be safely loaded and unloaded If the ramp sags appreciably, rein When loading and unloading the machine, park the trailer on a flat firm r oadbed.
Keep a fairly long distance between th e road shoulder and the machine. carriage to prevent the machine from slipping to the side on slopes. n and free of grease, oil, ice and loose materials. Remove the mud from the under carriage to prevent the machine from s lipping to the side on slop Be sure the ramp surface is clea n and free of grease, oil, ice and loose materials. Never change the direction of tra vel when on the ramps. If it is necessar y to change direction, driv e off the ramps and c orrect the direction, then drive on to the ramps again. When loading or unloading, alw ays use ramps or a platform. Proceed LOADING el ground only. m the edge of a road. 1.
Load and unload on firm lev Maintain a safe distance fro 2. Apply the trailer brakes secu tires to prevent the trailer fro Set left and right ramp equally spaced to the left Make angle of installatio ramps bend a large a machine, put blocks und bending. 1. Load and unload on firm lev 2. Apply the trailer brakes secu rely, then put blocks (1) under the m moving. s (2) parallel to each other and and right of center (3) of the trailer. n (4) a maximum of 15°. If the mount under the weight of the er the ramps to prevent them from 3. Start the engine. Warm the engine up fully. 4. Set parking brake lever to th e FREE position (F). 5.
Set the transmission in the 1st gear and run the engine at low 6. Set the travel direction towa rd the ramps and drive slowly. machine shifts suddenly at the border between the ra 7. The center of gravity of the machine is unbalanced and becomes dangerous. Accordingly , pass the border slowl 8. Stop the machine at the spe cified position on the trailer.