. OPERATION TRANSPORTATION 3 - 169 INSTALLATION OF C AB 1. Replacing cab seals 1) Raise the cab to r the operator's cab Weight of cab: (MSHA glass s (1,169 lb)) 2) Remove all the old 3) Remove any dirt o (A). 4) Remove the paper in the same positio The new seal is lon portion. 1. Replacing cab seals 1) Raise the cab to r eplace the seal at the m ating surface of the operator's cab assembly. Approx. 470 kg (1,036 lb) pecification machine: Approx. 530 kg seal with a scraper. r oil from the mounting surface of seal Weight of cab: Approx. 470 kg (1,036 lb 2) Remove all the old 3) Remove any dirt o (A).
4) Remove the paper backing from the new s eal, then stic k it in the same positio n as the old seal. The new seal is lon ger the necessary, so cu t off the excess portion. 530 kg 2. Replacing dashboard seal al and replace it with a new seal. f the seal with grease (G2-Li). 1) 2) 1) Remove the old se al and replace it with a new sea 2) Coat the outside o f the seal with grease (G (This is to make sl iding easier and prevent deformation of the seal when the cab is installed.) 3. Reinstalling cab the opposite order to removal. were disconnected. wly on top of the floor frame. the floor frame, then install bolts and A) - (U). ighten the bolts. Screw them in 3 or 4 n holes (N) - (U) fully.
r (N), (U), (Q), (R), (O), (T), (P), (S). o (M) completely. wiring harness connector and washer rder of removal. e the cab in reverse order of removal. Install the cab parts in Connect all parts that 1) Lower the cab slo 2) Align the cab with washers in holes ( Do not completly t turns. 3) Tighten the bolts i Tighten in the orde 4) Tighten bolts (A) t 5) connect the cab hoses in reverse o 6) Install covers insid nstall the cab parts in the opposite order to re Connect all parts that were disconnected. 1) Lower the cab slo wly on top of the floor fra 2) Align the cab with washers in holes ( Do not completly t turns.
3) Tighten the bolts i Tighten in the orde r (N), (U), (Q), (R), (O), (T), (P), (S). 4) Tighten bolts (A) t 5) connect the cab wiring harness connect hoses in reverse o 6) Install covers insid e the cab in reverse ord er of remova