Komatsu — GUIDES TO MAINTENANCE

. MAINTENANCE GUIDES TO MAINTENANCE 4 - 3 DUSTY WORKSITES: as follows: When working at dusty worksites, do Clean the radiator fins and other pa rts of the heat exchange equipment more frequently, and take care not to let the fins become clogged. tly. cially the starting motor and alternator, to avoid accumulation of dust. Replace the fuel filter more frequen Clean electrical components, espe cially the starting motor and alternator, to avoid accumulation of du When checking and replacing the o il or filters, move the machine to a place where there i s no dust and take care to prevent dust from entering the s ystem. AVOID MIXING OILS:

If a different brand or grade of oil has t o be added, drain the old oil and replace all the oil with the new brand or grade of oil. Never mix different brand or gra de of oil. LOCKING INSPECTION COVERS: Lock inspection cover securely into position with the lock bar. If inspection or maintenance is performed with inspection cover not locked in position , there is a danger that it may be suddenly blow shut by t he wind a nd cause injury to the worker. BLEEDING AIR: When hydraulic equipment has been repaired or replaced, or the hydraulic piping has been removed and installed again, the air must be bled from the 4-48)". circuit.

For details, see "BLEEDING AIR IN HYDRAULIC SYSTEM (PAGE PRECAUTIONS WHEN INSTALLING H YDRAULIC HOSES: where there are O-rings or gasket seals, clean the mounting surface, and orget to assemble the O-rings and gaskets. When removing parts at locations replace with new parts. When doing this, be careful not to f When installing the hoses, do not t wist them or bend them sharply. If they are installed so, t heir servi ce life will be shortened extremely and they m ay be damaged. CONTROLLER:

The controller for the machine monitor may be actuated mistakenly by radio wave interference f rom the o utside, so when installing any radio control equi pment to the machine, please consult your Komatsu distributor. CHECKS AFTER INSPECTION AND MA INTENANCE: If you forget to perform the checks afte r inspection and maintenance, unexpected problems may occur, an d this may lead to serious injury or property dam age. Always do the following: e stopped) nance points been forgotten? ance items been performed correctly? opped inside the machine? It is particularly dangerous if parts are dropped ght in the lever linkage mechanism. t or oil? Have all nuts and bolts been tightened?

Checks after operation (with engin Have any inspection and mainte Have all inspection and mainten Have any tools or parts been dr inside the machine and get cau Are there any leakage of coolan Checks when engine is running For the checks when the engine RUNNING (PAGE 2-30)" in the Check that the inspected and m Raise the engine speed and ch is running, see "TWO WORKERS FOR MAINTENANCE WHEN E NGINE IS SAFETY section, and take care of safety sufficiently