Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE REVERSE AND REPLACE THE END BITS AND CUTTING EDGES WARNING equipment lock lever. 3. Loosen nut (1) and remove bolt (2). Then remove the cutting edge and the end bit and clean the mounting surface. 4. Reverse or replace the cutting edge and the end bit when worn out. If bolt (1) and nut (2) are damaged, replace them with new ones at the same time. Tightening torque: 3340 6. After several hours of running, retourque the nuts. When the nut is rusted and is removed by gas cutting, cut on both side (6) of the nut as shown in the diagram. Be careful not to damage seat surface (7). If it is damaged, repair it. Be careful not to get spatter on the mounting surface.

4 - 35 It is dangerous if the work equip ment moves by mistake when the cutting edges and end bits are being reversed or replac work Reverse or replace the end bi ts and cutting edges before it is worn out to the blade end 1. Raise the blade to a proper height, position a block under the frame to prevent the blade from falling. 2. Operate the work equipment lock lever to the LOCK position. If the cutting edge and the end bit on both sides are worn out, replace with new one. If the mounting surface is worn, correct it before turning or replacing the end bits. e, then tighten partially.

Drop the bla de three to five times on to the grou nd or ro ck to ), then tighten it to the correct tightening torque. When in it (3), pu t top n close contact with stopper (5), then tighten with the bolt 0 ± 373 Nm (341 ± 38 kgm, 2466.3 ± REMARK The tightening operation is ea sier if the power wrench that has be