. OPERATION EXPLANATION OF COMPONENTS PARKING BRAKE LEVER WARNING When the machine is parked, always set the parking brake lever to the LOCK position (L). This lever (5) is used to apply the parking brake. WORK EQUIPMENT LOCK LEVER WARNING REMARK 3 - 47 REMARK Before moving th e parking brake lever to the LOCK position (L), return the steering, directional, and gearshift ition. lever to the N pos When starting the engine, if the parking bra ke lever is not in the LOCK position (L) , the limit switch is actuated and it is impossib le to start the engine.
and gearshift equipment lock leve If the blade control r securely to the LOCK positi and ripper control levers ar touched by accident , it may lead to serious injury damage. If the work equipmen t lock lever is not completely in the LOC K position (L), the lock may not be applied. e position shown in the diagram. achine or when performing maintenance, always Check that it is in th e position shown in the diagr When parking the m achine or when performing maintenanc lower the blade or r ipper to the ground, then se t the work e quipment lock lever to the LOC K position (L). Lever (6) is a device to lock the blade control and ripper control levers.
When it is set to the LOCK position (L), the TI LT, RAISE , LOWER, and FLOAT opera tions are locked. When starting the en gine, to ensure safety, al ways set th e work equipment lock lever to the LOCK position (