hitachi — Assembly of Standard Pilot Valve for Front Attachment

BODY (UPPERSTRUCTURE) / Pilot Valve 23. Install push rods (27) (4 used) to the plug (25) assemblies (4 used). 24. Install springs (29) (2 used), springs (45, 46) and washers (31) (4 used) to spools (32) (4 used) at the original position. 25. Insert spools (32) (4 used) through the larger hole on spring seats (28) (4 used). Push spring seats (28) (4 used), and compress springs (29) (2 used) and springs (45, 46). Slide and install spring seats (28) (4 used) to spools (32) (4 used). CAUTION: When push rods (12) (3 used) and push rod (18) are pushed too much by using screws (3) (4 used), looseness may occur at the neutral position. This may cause sudden machine movement when starting the engine.

28. Adjust the heights of screws (3) (4 used). Set levers (4) (2 used) in the vertical position to the upper surface of cover (9). By rotating lever (4) clockwise and counterclockwise, check that no looseness occurs at the neutral position. Tighten screws (3) (4 used) with nuts (2) (4 used). NOTE: Do not push spring seats (28) (4 used) to 6 mm (0.24 in) or more. 26. Install springs (30) (4 used) to casings (34, 48). Install the spool (32) assemblies (4 used) and the plug (25) assemblies (4 used) to casing (34, 48). Apply grease onto the top of push rods (27) (4 used). : 13 mm NOTE: If clearance exists, it may cause looseness in the angle at beginning of control lever (4) operation.

Check that no looseness found after tightening nut (2). 29. Spray rust proof oil onto the inner parts of boot (5). Insert the upper end of boot (5) into the groove on lever (4). Insert the lower end into the groove on cover (9). : 16.7 N m (1.7 kgf m, 12.5 lbf ft) NOTE: Do not hit the lower ends of spools (32) (4 used) against casings (34, 48) strongly. 27. Install covers (9) (2 used) and the detent casing (20, 44) assemblies to casings (34, 48). Insert and tighten socket bolts (1) (4 used) into the deeper hole on covers (9) (2 used). NOTE: Waterproof degradation may occur unless boot (5) is correctly inserted into the groove. : 5 mm NOTE:

Check the positions to install cover (9) and the detent casing (20, 44) assemblies to casing (34). : 8.8 N m (0.9 kgf m, 6.5 lbf ft) W2-8-19