hitachi — Maintenance Standard

BODY (UPPERSTRUCTURE) / Pilot Valve MAINTENANCE STANDARD 1. Spool (32) diameter Difference between diameter of non-sliding part (a) and sliding part (b) a-b Unit: mm (in) Allowable Limit 0.01 (0.0004) NOTE: In case the value is beyond the allowable limit, replace the pilot valve assembly. 2. Push rods (12, 18, 27) length Unit: mm (in) a b W4GB-02-06-016 12, 18 3. Bushing (14) inner diameter e Unit: mm (in) c 27 W4GB-02-06-017 d NOTE: When the bushing in the sub assembly of the solenoid is worn away, replace the solenoid valve assembly. 4.

Looseness in the control part When looseness on the upper end of lever (4) is 2 mm (0.08 in) or more due to the wear of screw (3), camshaft (8) or DU busing (7), replace the solenoid valve assembly. W4GD-02-08-001 W2-8-20 Standard Allowable Limit c 87.7 (3.45) 86.7 (3.41) d 36 (1.42) 36 (1.42) Standard Allowable Limit 8 (0.32) 8.5 (0.34) 14 e 14