57 Checking the Fan Belt Tension Check and adjustment of the fan belt tension 3 CAUTION To avoid personal injury: First stop the engine and remove the key. After servicing, make sure to replace the belt cover in its original position. (1) Engine oil dipstick (A) Required level 4. Let the engine idle for approx. 5 min. Check the engine oil level. To check the engine oil level, insert the engine oil dipstick completely into the respective port opening and pull out again. If the oil level lies between both markings, no oil must be added. 1. Press the fan belt down in the middle, with a force of approx. 98N (10kgf). The belt tension is correct if it defl ects about 0.3in. (8mm).
If otherwise, loosen bolt (1) and (2) and shift the dynamo in the direction shown by the arrow. 2. Replace the fan belt if worn out, cracked or torn. IMPORTANT: Regardless of the service hours, an engine oil change is due every six months. (1) Bolt (A) about 0.28in. (7 mm) (2) Bolt (3) Dynamo (4) Fan belt Engine oil volumes approx. 3.6 L (with replacing engine oil filter)