Kubota — Replacing of Fuel Filter

59 EVERY 500 SERVICE HOURS Replacing of Fuel Filter 3 CAUTION To avoid personal injury: Keep fi re away. Do all 50, 100 and 250 hour servicing at the same time. Drive unit Oil Change (First Oil Change at 100 hours) 3 CAUTION To avoid personal injury: Lower attachments to the ground, stop the engine and remove the key before undertaking the oil change. 1. Close the cock of the water separator. Remove the fi lter with the supplied fi fter wrench. 2. Add fuel to the new fi lter before installing. 3. Apply a light fi lm of fuel to the seal of the new fi lter and turn in tightly by hand. 1. Rotate the track so that the drain plug of the drive unit is in the bottom position. 2.

Remove the drain plug to let the oil run out. Screw in and tighten the drain plug again and fi ll with gear oil through the oil check port. 3. Fill oil until it overfl ows out of the oil check port. (1) Fuel fi lter Oil change - fi rst oil change after 100 hrs - then every 500 hrs - or at least once a year IMPORTANT: After exchange of the fi lter, the fuel system must purged. 4. Use prescribed gear oil SAE 90. (1) Oil check port (also serves as oil fi lling port) (2) Drain plug Gear oil volumes approx. 0.25 L