Kubota — Hydraulic Oil Change (including replacing of the suction filter in the hydraulic tank)

62 EVERY 1000 SERVICE HOURS 2. Remove the drain plug on the underside of the hydraulic tank and drain the oil. Do all 50, 100, 200, 250 and 500 hour servicing at the same time. Cleaning of the Pipe fi lter of the Hydraulic Pilot System Dust and dirt collect on the concave side of the fi lter. Clean the fi lter by letting hydraulic oil fl ow through from the convex side. (1) Drain plug 3. Remove the cover of the hydraulic tank. 4. With a fork wrench or similar, remove and exchange the suction fi lter. (A) Oil Hydraulic Oil Change (Including Replacing of the Suction Filter in the Hydraulic Tank) 3 CAUTION To avoid personal injury: Wait long enough for the hydraulic fl uid to cool down.

Then begin with the change of the hydraulic fl uid. (1) Cover (2) Suction fi lter (3) Drain plug 5. Retighten the drain plug. 6. Fill oil through the oil fi lling opening on the top side of the tank. 7. Let the engine run for approx. 5 min. and check the oil level again. 1. Move the excavator to a level ground and stop the engine. Extend the piston rods of the cylinders halfway out and lower the bucket on the ground. Hydraulic oil volumes Hydraulic tank 13 L Whole oil volumes 21L