Komatsu — 6.6.3.1 INSTALLING THE HAMMER

ARRANGEMENT FOR THE INSTALLATION OF THE DEMOLITION HAMMER 6.6.3 INSTALLING AND REMOVING THE DEMOLITION HAMMER 6.6.3.1 INSTALLING THE HAMMER DANGER The machine must be parked on flat ground, with the front equipment resting on the ground. For the installation, the hammer must be positioned horizontally, with the end directed towards the ma- chine. When the coupling pins are removed or installed, chips may come off; always wear gloves, safety gog- gles and helmet. The change of the equipment must be carried out by two operators, who must decide together the words and signals to be used during operations. Do not use your fingers to center the holes, since they may be injured or even cut.

Release the residual pressure that may be present in the pipes completely. Before carrying out any operation on the hydraulic circuit, eliminate the residual pressure from the equipment circuits by moving the controls more than once and from the tank by slowly loosening the filling cap. Immediately clean any area dirty with oil. For the installation of the demolition hammer it is necessary to connect the mechanical constraints of the back- hoe bucket as described in “3.13.5 CHANGING THE BACKHOE BUCKET” and to carry out the hydraulic connec- tions using the pipes provided. After connecting the mechanical constraints, carry out the hydraulic connections by proceeding as follows:

1 - Stop the engine and move the hydraulic controls in all directions, in order to completely release the residual pressures present in the circuits of the machine. 2 - Press the hammer control pedal to release the pressure present in the hammer delivery pipe. RWA35090 232