APPLICATION OF THE OFFSET DEVICE 6.7 APPLICATION OF THE OFFSET DEVICE DANGER When it is necessary to move the machine or travel on roads, the offset device must be positioned cen- trally with respect to the boom axis. To carry out digging operations on vertical walls, the fulcrum pin (1) of the revolving support (2) must be perfectly vertical; be very careful to the position of this component when digging near walls and posts, wells and underground lines. When digging near walls, take care not to weaken foundations and cause collapses.
When working beyond the outline of the machine, make sure that the ground on which the stabilizers and wheels rest is solid and the area is sufficiently far from ridges, banks, coasts: remember that in these conditions the specific pressure on the ground always increases. Reduce the loads and work at low speed, in order to ensure the stability of the machine. 6.7.1 DESCRIPTION AND CONTROL 3 1 4 2 5 RWA03750 5 3 2 RWA03760 4 4 2 EDGE OF THE WHEEL RWA04150 235 The offset device is an integral part of the boom (3) and makes it possible to dig beyond the outline of the machine.
If the offset device is in neutral position, the boom can be used as a normal boom; if it is necessary to dig beyond the machine’s outline, it is necessary to shift the backhoe and operate the de- vice in order to restore the parallelism between the arm (4) and the machine axis. The operation of the cylinder (5) that produces the rotation of the support (2) to which the arm (4) is mechanically constrained is achieved through an additional distributor controlled by a pedal (6) positioned on the left side of the backhoe control lever unit. The levers maintain the functions described at point “3.3.6 (pos. 15-16) BACKHOE CONTROL LEVERS”) unchanged.
The controls that operate the offset device are the following: 1 - The swing to the right is obtained by pressing the pedal with the toe. 2 - The swing to the left is obtained by pressing the pedal with the heel. 6 6 RWA35220