ARRANGEMENT FOR THE INSTALLATION OF THE CLAMSHELL BUCKET 240 6.9.2 INSTALLING THE CLAMSHELL BUCKET DANGER • The machine must be parked on flat ground, with the front equipment resting on the ground. • When the coupling pins are removed or installed, chips may come off; always wear gloves, safety goggles and helmet. • The change of the equipment must be carried out by two operators, who must decide together the words and sig- nals to be used during operations. • Do not use your fingers to center the holes, since they may be injured or even cut. • Release the residual pressure that may be present in the pipes completely.
A 2 3 4 4 DANGER • The machine must be parked on flat ground, with the front equipment resting on the ground. • When the coupling pins are removed or installed, chips may come off; always wear gloves, safety goggles and helmet. • The change of the equipment must be carried out by two operators, who must decide together the words and sig- nals to be used during operations. • Do not use your fingers to center the holes, since they may be injured or even cut. • Release the residual pressure that may be present in the pipes completely. 2 3 4 4 To install the revolving clamshell bucket, proceed as follows: 1 - Remove the standard bucket from the backhoe (See “3.13.5 CHANGING THE BACKHOE BUCKET”).
2 - Retract the bucket control piston completely. 3 - Connect the clamshell bucket to the arm. 4 - Stop the machine and move the controls in all directions to release the residual pressures. 5 - Mechanically lock the standard bucket thrust lever, in such a way as to lock the piston at the end of its stroke. 1 RWA17400 B RWA17400 1 B CAUTION CAUTION • During the following steps, take care to prevent any impu- rities from getting into the pipes and the cylinder. FOR STANDARD ARM (FIG. A) 6 - Disconnect the pipes (2-3) that operate the piston from the bucket cylinder (1) and seal the cylinder couplings (4). FOR TELESCOPIC ARM (FIG.
B) 6 - Disconnect the piston control pipes (2-3) from the bucket cyl- inder (1) and seal the cylinder couplings (4). 7 - Connect the pipes disconnected from the cylinder to the cou- plings for the opening and closing of the clamshell bucket. 8 - Remove the plugs from the rigid pipes of the system and con- nect the pipes. 9 - Start the machine and raise the clamshell bucket a few centr- imetres from the ground. 2 4 3 4 1 RWA17390 RWA17390 2 4 3 4 1