ARRANGEMENT FOR THE INSTALLATION OF THE MANUAL HYDRAULIC HAMMER 6.10.2 CONNECTING AND REMOVING THE HAMMER DANGER The connection and removal of the hammer must be carried out with the machine parked and the equipment resting on the ground, parking brake applied and control lever safety locks engaged. Completely release any residual pressure from the pipes before connecting or disconnecting the ham- mer. 6.10.2.1 CONNECTING THE HAMMER To connect the hammer, proceed as follows: 1 - Stop the engine and move the hydraulic controls in all directions, in order to release any residual pressure from the circuits of the machine.
2 - Turn the ignition key to positi « » ” and press the hammer control push button (4) to release the residual pres- sure from the hammer delivery pipe. 3 - Turn the ignition key to position « ». 4 - Make sure that the couplings are perfectly clean and connect the hammer. 5 - Start the engine and press the push button (4) to enable the hammer circuit. 6 - Increase the engine speed to the rpm indicated in the technical data by means of the manual accelerator and then start working. 6.10.2.2 REMOVING THE CONNECTIONS If quick attachments are not provided, place sealing plugs with the relevant gaskets on the couplings of the machine and of the hammer.
DANGER Make sure that the plugs are properly tightened and that there are no leakages; if the circuit is inadvert- ently pressurized, small leakages can be turned into thin jets that may perforate the skin or injure the eyes. Always wear thick gloves and safety goggles to carry out this check. To check the system for leaks, use a piece of cardboard or a wooden board. 243 At the end of work, proceed as follows 1 - Press the push button (4) to disconnect the circuit, reduce the engine rpm and stop the engine. 2 - Move the hydraulic controls more than once in all directions, in order to release any residual pressure from the circuits of the machine.
3 - Turn the ignition key to position « » and press the hammer control push button (4) to release the residual pressure from the hammer delivery pipe; after releasing the pressure, press the push button (4) again to dis- connect the circuit. 4 - Turn the ignition key to position « ». 5 - Disconnect the hammer. CAUTION CAUTION