Komatsu — Komatsu K EAM04 9 700 T Operation and Maintenance Manual for Bulldozers

OPERATION OPERATION CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil temperature to go down before performing this operation. 1. Open the engine side cover on the left side of the chassis. 2. Remove dipstick (G) and wipe the oil off with a cloth. 3. Fully insert dipstick (G) into filler pipe (F), then remove it. 4. The oil level should be between the MAX and MIN marks on dipstick (G). If the oil level is below the MIN mark, add engine oil through oil filler (F). 5. If the oil level is above the MAX mark, remove cover (1) at the bottom of the machine.

Loosen drain valve (P), drain the excess oil, then check the oil level again. 6. If the oil level is correct, tighten the oil filler cap securely and close the engine side cover. REMARK If the machine is at an angle, reposition it to level before checking. When checking the oil level after the engine has been operated, allow the engine to cool for 15 minutes before checking. 3-75 WARNING