Komatsu — Komatsu K EAM04 9 700 T Operation and Maintenance Manual for Bulldozers

OPERATION OPERATION FASTENING AND REMOVING SEAT BELT q Before fastening the seat belt, check that there is no problem in the securing brackets or belt. If there is any wear or damage, replace. q Even if there appears to be no problem in the seat belt, replace the seat belt once every 3 years. The date of manufacture is woven on the reverse side of the belt. q Adjust and fasten the seat belt before operating the machine. q Always use the seat belt when operating the machine. q Do not use the seat belt with either half of the belt twisted. Check that the bolts of the clamp securing the belt to the chassis are not loose. Tighten them if they are loose.

The tightening torque for the mounting bolt is 24.5 ± 4.9 N·m (2.5 ± 0.5 kgf·m, 18.1 ± 3.6 lbft). If the belt surface is scratched or frayed or if the fittings are broken or deformed, replace the seat belt unit. FASTENING AND REMOVING SEAT BELT 1. After adjusting the seat position, adjust tether belt (1). Tense the tether belt and install it when there is no one sit- ting on the seat. 2. Sit on the seat and hold tongue (4) connected to wind-in mechanism (2) and pull out the belt slowly so that the belt will cover your abdomen sufficiently. 3. Insert tongue (4) in buckle (3) until it clicks. The belt is pulled back into wind-in mechanism (2) until it is fitted to your abdomen.

The belt is locked under this condition and cannot be extended anymore. Fit the belt to your abdomen without twisting it. REMARK If the belt is locked before the tongue is inserted in the buckle, let it return to the wind-in mechanism, then repeat the above procedure from the start. 4. Pull the belt to check that it is securely locked in position. 5. When removing the belt, press the red button on buckle (3). The belt will automatically be wound in. 3-84 WARNING