Komatsu — Komatsu K EAM04 9 700 T Operation and Maintenance Manual for Bulldozers

OPERATION OPERATION 2. After warm-up run is completed, check gauges and caution lamps for proper operation. If any abnormality is found, repair it. Continue to run the engine under a light load until engine coolant temperature gauge indicator (2) is within the green range (B). (A): White range (B): Green range (C): Red range 3. Check for abnormal exhaust gas color, noise, or vibration. If any abnormality is found, contact your Komatsu distributor. STARTING IN COLD WEATHER 3 (Ambient temperature below 10°C (50°F)) NOTICE q When the hydraulic oil is at a low temperature, do not carry out operations or move the levers suddenly. Always carry out the warm-up operation.

This will help to extend the machine life. q Do not suddenly accelerate the engine before the warm-up operation is completed. Do not run the engine at low idle or high idle con-tinu- ously for more than 20 minutes. This will cause leak- age of oil from the turbocharger oil supply piping. If it is necessary to run the engine at idle, apply a load from time to time or run the engine at a mid-range speed. 1. After starting the engine, run it for approx. 10 minutes under no load (warming-up operation). 2. Blade control lever (1) to the full RAISE position, then hold the lever in position, and operate slowly to the left tilt relief and right tilt relief positions for 5 minutes. 3.

After this, operate the blade control lever (1) fully to the RAISE position, hold the lever in position, and relieve the left and right tilt intermittently. Next, move the lever to the LOWER position and lower the blade to the ground, then move the lever to the full FLOAT position, hold the lever in position, and relieve the left and right tilt intermittently for 5 minutes. 4. Lower the blade to the ground, move the control lever fully to the FLOAT position (lever stroke end) and hold the lever in position for 1 minute. Next, release the lever and check that it stays in the FLOAT position. After waiting for 3 min- utes, return the lever to the HOLD position.

(A) (B) (C) RAISE HOLD LOWEW (D) (E) (F) FLOAT LEFT TILT RIGHT TILT 3-95