TRANSPORTATION OPERATION TRANSPORTATION 3 When transporting the machine, observe all related laws and regulations, and be careful to assure safety. TRANSPORTATION MEANS 3 As a rule, transport the machine on a trailer. Select a trailer according to the mass and dimensions of the machine shown in “SPECIFICATIONS (5-2)“. Note that the mass and dimensions for transportation shown in SPECIFICATIONS depend on the types of shoe, blade, etc. REMOVING CAB 3 If it is necessary to remove the cab for transportation, there is danger that the seal may be damaged when remov- ing or installing the cab, so please contact your Komatsu distributor.
When installing the cab, please contact your Komatsu distributor, too. PRECAUTIONS WHEN REMOVING WORK EQUIPMENT 3 POWER ANGLE, POWER TILTDOZER 3 (For D61PX) 1. Lower the blade to the ground and set it horizontal to the ground surface. 2. Remove the blade assembly. REMARK If the blade of D61EX is angled, its width is shorted to less than 3.0 m (9 ft 10 in). Accordingly, the blade of D61EX does not need to be removed. POWER TILTDOZER 3 If there is any pressure remaining in the tilt piping after the work equipment has been removed, it may be difficult to remove the quick coupler of the tilt hose, so remove the work equipment as follows. 1.
Lower the blade to the ground and set it horizontal to the ground surface. REMARK If the blade is tiled, the tilt piping will be under internal pressure, so set the blade horizontal to the ground. 3-118