Komatsu — Komatsu K EAM04 9 700 T Operation and Maintenance Manual for Bulldozers

OPERATION TROUBLESHOOTING PRECAUTIONS FOR BATTERY CHARGING 3 If the battery is charged improperly, it may explode. Accord- ingly, charge it according to “IF BATTERY IS DISCHARGED (3-138)“ and the instruction manual attached to the charger, and observe the following items. q Set the voltage of the charger to match the voltage of the battery to be charged. If the correct voltage is not selected, the charger may overheat and cause an explosion. q Connect the positive (+) charger clip of the charger to the positive (+) terminal of the battery, then connect the nega- tive (-) charger clip of the charger to the negative (-) termi- nal of the battery. Be sure to fix the clips securely.

q Set the charging current to 1/10 of the value of the rated battery capacity; when carrying out rapid charging, set it to less than the rated battery capacity. If the charger current is too high, the electrolyte will leak or dry up, and this may cause the battery to catch fire and explode. q If the battery electrolyte is frozen, do not charge the battery or start the engine with a different power source. There is a danger that this will ignite the battery electrolyte and cause the battery to explode. q Do not use or charge the battery if the battery electrolyte level is below the LOWER LEVEL line. This may cause an explosion.

Check the battery electrolyte level periodically and add distilled water to bring the electro- lyte level to the UPPER LEVEL line. STARTING ENGINE WITH BOOSTER CABLE 3 When starting the engine with a booster cable, do as follows: PRECAUTIONS WHEN CONNECTING AND DISCONNECTING BOOSTER CABLE q When connecting the cables, never contact the posi- tive (+) and negative (-) terminals. q When starting the engine with a booster cable, wear safety glasses and rubber gloves. q Be careful not to let the normal machine and problem machine contact each other. This prevents sparks from generating near the battery which could ignite the hydrogen gas given off by the battery.

q Make sure that there is no mistake in the booster cable connections. The final connection is to the engine block of the problem machine, but sparks will be gen- erated when this is done, so connect to a place as far as possible from the battery. q When disconnecting the booster cable, take care not to bring the clips in contact with each other or with the machine body. 3-139 WARNING